Oatsbasf Protective Aluminum Metal Frame Bumper Case For OnePlus 6

$15.99
Out of stock
SKU
OP600068
  • Made from the highest quality Aviation aluminum material.
  • Designed with raised edges lift the camera and screen away from flat surfaces for better protection.
  • Designed with precious cutouts in corners and bumpers for nice signal receiving.
  • Bumper case has better heat dissipation than plastic case.
  • The bumper case protects your OnePlus 6 from getting hot in use especially while charging.

Oatsbasf Protective Aluminum Metal Frame Bumper Case Fo OnePlus 6:

SHOCK-ABSORPTION PROTECTION

This OnePlus 6 bumper case is designed with 4 Detachable Air Cushion Silicon Pads in the 4 corners. The elastic silicon pads are higher than corners, provides nice drop resistance. Raised edges lift the camera and screen away from flat surfaces.

RAISED EDGES PROTECTION

This  OnePlus 6 bumper is designed with raised edges lift the camera and screen away from flat surfaces for better protection of your device.
Precise cutouts for all buttons and ports, convenient to use. No signal blocking

NO SIGNAL BLOCKING

This OnePlus 6 bumper case is designed with precious cutouts in corners and bumpers for nice signal receiving. No signal blocking.

INSTALLATION INSTRUCTIONS

1. Put the case back up, then loosen four screws with screw driver and remove the 4 corners;
2. Put your phone back up and put the camera corner on the camera, then put the bumper part. Insert the tiny pillar into the hole of the camera corner. Then tighten the screw for 3 rounds, but not too tight;
3. Put the other 3 corners clockwise in the same way;
4. Check to make sure the bumper part are well inserted into the 4 corners;
5. Tighten the 4 screws to the utmost, so it will not loosen easily.

More Information
Compatible OnePlus 6
Category Cases/Cover
Material Aviation aluminum
Write Your Own Review
Write a ReviewOatsbasf Protective Aluminum Metal Frame Bumper Case For OnePlus 6